There are two big considerations when it comes to knowing how to correctly use a plunger. First, you should understand how a plunger works when used properly. Then you can apply that knowledge towards successful completion of this common do-it-yourself chore.

4) You will need to have on hand water leak tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.

There are two, one on each side of the toilet, closet bolts which hold the toilet to the floor. If there are caps over the bolts, remove or pop them open. Using a small crescent wrench unscrew the nuts from the bolts. Alternate side to side when unscrewing this will be much more important when reinstalling the water line repair bolts but alternate anyhow.



The first thing you need to do after leakage starts is to shut the water supply before you remove the faucet. You can either shut the valve in the sink or the main valve of your home. After that ensure that the water in the water line is drained and also the air pressure s released. This will also help in saving a lot of water that might have been wasted due to the leakage.

The location of a plumbing contractor is a key factor. This is because he or she will not only charge you an hourly rate, but travel costs will also be charged. This can add a significant amount to the final bill if the contractor has to travel from the other side of town.

If you do not have hot water in your home, it may be a bit tricky for you to attempt to find out what the cause is yourself. If you have a tank that is leaking, this may be the reason why you do not have any hot water. If you have an electrical unit, the causes may be things such as a bad heating element, fuses that are blown, an overload switch which is bad, circuit breakers not working properly or faulty thermostats. If you have a gas tank, the problems causing you to not have hot water line repair may include a problem with the thermocouple burners. In situations like these, it is imperative that you contact a reputable plumbing company to get everything squared away.

For a newly installed icemaker, you will need up to 24 hours to let the machine function and cool down. A newly installed icemaker may not work until the ice mold temperature has dropped to about 15F - 16F degrees. If you have just added a water line to the refrigerator, it may take up to about an hour and a half for the machine to start working. Also, a newly installed water line may have air in the line. It can sometimes take a few ice making cycles to clear the line of air.

Over the counter drain cleaning products offer convenience and effective results. However, they are best left to those who need to simply improve the flow of water, not those who need to repair it.